Specialty Anchors - Pegboard

Description:

Built-in spacers hold the pegboard the proper distance from the wall to allow peg hooks to work. The anchors eliminate furring strips, letting you configure the peg hooks in any arrangement you choose, quickly and easily, without losing the use of entire lines of peg holes.

May be also used as a stand-off for installing equipment on warm or wet walls when ventilation is needed behind the installed object.

Installation:

• Position pegboard on wall and hold it in place with nails in corner peg holes. Mark every 24th hole across and down the pegboard for anchor locations. (Space anchors closer for extra support.) Remove pegboard and nails.
  
• Drill a 5/16" diameter hole at each mark—minimum hole depth in solid walls 1-1/4". Fold anchor, insert in hole, and tap flush with wall.
  
• Insert black key to pop anchor open behind wall (except in thick or solid walls). DO NOT HAMMER KEY. Remove key.
  
• Place pegboard over anchors. Insert screws and tighten flush with pegboard—then stop.
  Use enclosed screws or any #8 x 1-3/4" pan head screw with a washer or a screw with a head larger than the peghole.
  
• The anchors also wedge securely in thick and solid walls. Do NOT use key.
  These anchors may also be used to install double-slotted shelving standards.
  Minimum quantity TBS2 anchors for following board sizes: 2'x2' (4), 2'x4' (6), 4'x4' (9), 4'x8' (15).

Manufacturer: Toggler

For More Information on the Specialty Anchors - Pegboard, [Click Here] to Link to Manufacturer Web Site