Details
Description:
Designed specifically for wire shelving systems, each anchor is equipped with a retainer clip that locks the shelving in place. The shelf will not tip—even when the weight is distributed unevenly or near the edge.
Ideal for use with systems like ClosetMaid or SCHULTE. Perfect for closet systems, kitchen shelves, and garage or workshop shelves.
Use TOGGLER hollow-wall anchors for installing shelf supports and end brackets.
ClosetMaid is a registered trademark of Emerson Storage Solutions. SCHULTE is a registered trademark of SCHULTE Corporation.
Installation:
- Mark a horizontal level line the length of the shelf 5/8" below the desired shelf top height. Make a mark 2-1/2" in from each end and additional marks spaced equally in between. (See recommended minimum quantity below.)
- Drill a 5/16" diameter hole at each mark—minimum hole depth in solid walls 1-1/4". Fold anchor, insert in hole, and tap flush with wall.
- Insert black key to pop anchor open behind wall (except in thick or solid walls). DO NOT HAMMER KEY. Remove key.
- Snap shelf onto anchors and let it hang down against wall. Place plastic retainer over anchor, insert screw and tighten flush with retainer—then stop.
Use enclosed screws or any fully-threaded #8 x 1-3/4" pan head screw.
- The anchors also wedge securely in thick and solid walls. Do NOT use key.
Minimum quantity TBW anchors for following shelf lengths: 24" (3), 36" & corner shelf (4), 48" (5), 60" (6), 72" (7).
Follow shelf manufacturer's instructions for installing shelf supports and end brackets, using TOGGLER BRAND TB or TC hollow-wall anchors.